Table of Contents
Advertisement
Chapter 5
Ethernet Communications (Option)
5.1
Connecting to the Network
When Connecting to a PC on the Network
E T
H E
1 0 0
R N
B A
E T
S E
-T X
100BASE-TX port
RJ-45 modular jack
Connecting to the PC in a One-to-One Configuration
IM WT3001E-51EN
1.
Turn OFF the power switch of this instrument(see section 3.4 in the User's Manual
IM WT3001E-01EN).
2.
Connect one end of the UTP (or STP) cable to the ETHERNET 100BASE-TX
terminal on the rear panel.
3.
Connect the other end of the UTP (or STP) cable to a hub or router.
4.
Turn ON the power switch of this instrument.
1.
Turn OFF the power switch of this instrument(See section 3.4 in the User's
Manual IM WT3001E-01EN).
2.
Connect one end of the UTP (or STP) cable to the ETHERNET 100BASE-TX
terminal on the rear panel.
3.
Connect the other end of the UTP (or STP) cable to a hub or router.
4.
Likewise, connect the PC to a hub or router.
5.
Turn ON the power switch of this instrument(see section 3.4 in the User's Manual
IM WT3001E-01EN).
Note
•
When connecting this instrument and a PC in a one-to-one configuration, use a 10BASE-
T/100BASE-TX auto switching NIC or a 100BASE-TX NIC on the PC side.
•
Use UTP (Unshielded Twisted-Pair) or STP (Shielded Twisted-Pair) cables of straight type
and category 5 or better.
•
Do not connect this instrument and a PC directly without going through a hub. Operations
are not guaranteed for communications using direct connection.
Hub or router that supports 100BASE-TX
UTP cable
or
STP cable
(Straight)
Hub or router that supports 100BASE-TX
UTP cable
or
STP cable
(Straight)
1
2
3
4
5
6
PC
7
Ethernet NIC
8
9
10
11
PC
12
13
Ethernet NIC
Index
5-1
Advertisement
Table of Contents
