Table of Contents
Advertisement
7.4 Changing the Displayed Items of Numeric Data
Explanation
7-20
The following limitations on changing the displayed items exist depending on Item
Amount (the number of displayed items).
Number of Displayed Items
4 Items, 8 Items, 16 Items
ALL Items
Measurement function display
(left side of the screen)
Single List
or
Dual List
Harmonic order data display
(right side of the screen)
• When Numeric Form (the Number of Displayed Items) Is 4 Items, 8 Items,
or 16 Items
• Changing the Measurement Function
• The selectable measurement functions are the items indicated in section 7.1,
"Harmonic Measurement Function."
• You can also select not to display the measurement functions (None).
• Changing the Element/Wiring Unit
You can select the element/wiring unit from the choices below. The selectable items
vary depending on the installed elements.
Element1, Element2, Element3, Element4, ΣA, and ΣB
• Changing the Order
When the measurement mode is set to normal measurement, waveform
computation, or FFT, the measured order can be set to normal measured value (---)
th
or from dc (0
order) up to 100
When the measurement mode is set to wide bandwidth harmonic measurement mode,
the measured order can be set to total value or from dc (0
Changing the Displayed Items
The displayed item cannot be changed
independently. Switch the display using the
cursor keys or by page scrolling. The order can
be selected on the harmonic data display on six
or seven pages.
The displayed item cannot be changed
independently. Switch the display using the
cursor keys or by page scrolling.
Only the measurement functions that contain
harmonic order data can be selected. (U, I, P,
S, Q, λ, φ, φU, φI, Z, Rs, Xs, Rp, and Xp)
th
order.
Change the measurement
function of the third item
Change the element
of the third item
Yes
th
th
order) up to 100
order.
Change the order
IM WT3001E-51EN
Advertisement
Table of Contents
