Selecting The Pll Source - YOKOGAWA WT3002E User Manual

7.5

Selecting the PLL Source

Procedure
7-22
RESET SET
Cursor keys
PAGE PAGE
SCALING LINE FILTER AVG
MOTOR FREQ
SET FILTER
HRM SET MEASURE SYNC SOURCE
CURSOR NULL
FILE IMAGE SAVE STORE
MENU STORE SET
PRINT MISC HELP
MENU
1.
Press HRM SET to display the Harmonics menu.
2.
Press the PLL Source Up Exec or the PLL Source Down Exec soft key to select
the PLL source. The selected PLL source is displayed in the upper right corner of
the screen at PLL Source.
• Press the PLL Source Down Exec soft key to switch the selected PLL source as follows:
U1 –> I1 –> U2–>I2 and so on.
• Press the PLL Source Up Exec soft key to switch the selected PLL source as follows:
I2 –> U2 –> I1 –> U1 and so on.
Normal measurement
mode
DISPLAY ITEM & ELEMENT
WAVE U / I / P
NUMERIC
WP/q/
OTHERS
TIME
ITEM FORM USER
LOWER ITEM LOWER FORM USER SET
To exit the menu during operation, press ESC located above the
soft keys.
In the procedural explanation below, the phrase "press the cursor
keys" may be used. This phrase refers to the procedures for
selecting items and entering values and character strings. For
details on the procedures, see section 3.14 in the User's Manual,
IM WT3001E-01EN.
Wide bandwidth
harmonic measurement
mode
UPDATE
HOLD
RATE
SINGLE
CAL
ELEMENT INTEG
START STOP
ALL
IEC harmonic
measurement mode
IM WT3001E-51EN
REMOTE
LOCAL
SHIFT