Installing Optional Modules; Figure 3-9 Loosening The Screws And Removing The Cover Plate; Table 3-4 Gigabit 1000Base Intelligent Module Series Led Description - ZyXEL Communications ZyXEL EES-1024AF User Manual

•
LK, ACT, FD and COL LEDs
•
Supports connection distance of up to 10 kilometers (using 9/125um Single-mode fiber) via fiber optic cable.
•
Support SNMP management
Front Panel LEDs
There are four LED indicators for the fiber port.

Table 3-4 Gigabit 1000Base Intelligent Module Series LED Description

LED COLOR
LK Green
ACT Green
FD Yellow
COL Yellow

3.6 Installing Optional Modules

You can install two optional modules separately to meet the needs of your network. The procedure for installing the
optional modules is the same. Follow these steps to install the optional modules.
Turn off your switch and unplug the power cord from the switch.
Step 1.
Loosen the thumbscrews from the cover plate and remove the cover plate from the optional slot. Do not
Step 2.
discard the cover plate. You can put the cover plate back on if you remove the new module.

Figure 3-9 Loosening the Screws and Removing the Cover Plate

Ground yourself by wearing an anti-static wrist strap or touching any grounded or metal objects before
Step 3.
you continue.
Remove the optional module from its protective anti-static packaging. Avoid touching the onboard
Step 4.
circuit components by holding it by the edge.
Insert the optional module into an avaliable expansion slot on the switch. Press it firmly until the
Step 5.
optional module snaps into place and secure it to the switch with the retaining screws.
Optional Modules
EES-1024AF Intelligent Ethernet Switch Optional Modules Guide
STATUS
On The port is connected to an Ethernet device.
Off The port is not connected to an Ethernet device.
Blinking The port is transmitting or receiving data.
On The port is operating in full-duplex mode.
Off The port is operating in half-duplex mode.
Blinking Data packet collision occurred on this port.
DECRIPTION
3-7