The VES-1012 uses two 250V-3A fuses. The VES-1012 comes with four 250V-3A fuses; two are installed at the
factory (in the fuse housing), while the two are spares that come with your VES-1012. If you need to install new
fuses, follow the procedure below.
Before you begin, you will need:
•
A small flat head screwdriver
•
250V 3A fuse(s)
•
Good lighting
Removing and Installing Fuses
Removing Fuses
Safety first! Disconnect all power from the VES-1012 before you begin this procedure.
Place the rear panel of the VES-1012 in front of you.
Step 1.
Remove the power cord from the back of the unit for easy access to the fuse housing as shown next.
Step 2.
Using a small flat head screwdriver, gently open the left side of the fuse housing located to the right of
Step 3.
the power cord port as shown next.
Appendix A Removing and Installing a Fuse
Removing and Installing a Fuse
This appendix shows you how to remove and install fuses for the VES-1012.
Diagram 1 Removing the Power Cord
VES-1012 Hardware Installation Guide
Appendix A
A