Skoda FABIA II 2007 Workshop Manual page 1245

♦ Socket insert - T10107A- or socket insert 6 mm, commercially
available
♦ Thrust piece - T30028 (3305)-
♦ Sealing grease - G 052 128 A1-
♦ Catch pan
Removing
• Observe the general repair instructions
⇒ "3 Repair instructions", page 4
• Do not remove both drive shafts simultaneously from the gear‐
box. There is no other possibility to hold the opposite wheel in
order to remove or install the screws of the rigid shafts.
• Do not undo the two securing bolts in the left and right rigid
shafts at the same time, and do not remove both rigid shafts
from the gearbox at the same time. If the differential bevel
gears twist, it will be difficult to reinstall the rigid shafts.
– Shift selector lever into position P.
– Remove the sound dampening system ⇒ Body Work; Rep.
gr. 50 .
– Remove the protective cap for right drive shaft from the engine
-arrows-.
– Unscrew the nuts -arrows- from the steering joint to the right
track control arm.
– Unhook the steering joint from the right track control arm.
Note
It is not necessary to slacken the screw connection of the drive
♦
shaft on the wheel side.
The drive shaft must not be removed, it is sufficient to tie it up.
♦
Caution
The drive shaft must not hang down, because overstretching
will cause damage to the inner joint.
– Press off the drive shaft from the rigid shaft of the gearbox e.g.
using a tyre iron.
Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
.
Gearbox 0AM-DSG - Edition 01.2015
1. Replace gasket rings for rigid shafts and flange shafts
183