Replacing Gasket Ring For Right Rigid Shaft (Octavia Ii, Superb Ii, Yeti) - Skoda FABIA II 2007 Workshop Manual

Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Octavia II 2004 ➤ ...
Gearbox 0AM-DSG - Edition 01.2015
– Fill half the space between the sealing lip and dust lip with
sealing grease - G 052 128- .
– Drive in new gasket ring with thrust piece - T30028 (3305)- up
to the stop.
• When driving in the gasket ring, ensure that the new gasket
ring is not tilted.
– Replace the O-ring -1- at the rigid shaft.
– Replace the circlip -2- at the rigid shaft.
– Insert rigid shaft.
– Tighten the new conical screw on the rigid shaft to the speci‐
fied tightening torque.
– Install left drive shaft ⇒ Chassis; Rep. gr. 40 .
– Change gearbox oil
Note
The gearbox oil must be changed, only in this way the correct gear
oil level can be ensured.
– Install left front wheel ⇒ Chassis; Rep. gr. 44 .
If the front left vehicle level sensor - G78- was removed, then the
headlight beam setting must be checked ⇒ Electrical System;
Rep. gr. 94 .
– Install the noise insulation ⇒ Body Work; Rep. gr. 50 .
Tightening torque
Component
Rigid shaft on gearbox (conical screw)
1.3 Replacing gasket ring for right rigid shaft
(Octavia II, Superb II, Yeti)
Special tools and workshop equipment required
182
Rep. gr.39 - Final drive - differential
⇒ "5 Change gearbox oil", page 174
⇒ "1.1 Summary of components - gasket rings and output shafts",
.
Nm
page 178