AGFA DX-D 600 User Manual page 71

.
Note
4.1.1 WORKSTATION SELECTION
.
Note
0242F EN 20181218
Press on Configuration Areas buttons to access to them.
INFO check exposition configuration: Patient data, Collimation and APR

configuration, X-ray Tube position, Technique and AEC configuration.
POSITION configure the X-ray Tube position.

RAD for Technique configuration and modification.

PROGRAMMED POSITION (PP). Configure X-ray Tube position and

other radiological parameters automatically.
It is possible to change at any moment the Area.
Depending on the Ceiling Suspension Configuration some of the
Configuration Areas might not be displayed on the Touchscreen
Console.
Workstation Buttons are always available for changing the desired option.
DIRECT WORKSTATION: Press to select Direct exposure when the
DR Detector is not required. When selected it is possible to execute an
exposure at any moment without DR Detector and X-ray Tube alignment. AEC
Controls, Auto-center and Auto-tracking movements are not available in Direct
Workstation.
RAD TABLE WORKSTATION: Press to select exposure with the DR Detector
of the RAD Table. When this option is selected the Active Workstation Indicator
of the RAD Table (under top Base Cover) gets lighted. In Single Panel
Systems it can be selected to work with the RAD Wall Stand DR in horizontal
position.
RAD WALL STAND WORKSTATION: Press for an exposure with the
DR Detector of the RAD Wall Stand. When this option is selected the Active
Workstation Indicator of the RAD Wall Stand (at the Top Cover) gets lighted.
Once the Workstation is modified or selected, this selection is
automatically transferred to the X-ray Generator.
DX-D 600
User Manual
63