AGFA DX-D 600 User Manual page 171

SECTION 10
10.1 OPERATOR TASKS
0242F EN 20181218
PERIODIC MAINTENANCE
In order to assure a continuous and safe performance of the system, a periodic
maintenance program must be established. It is the owner's responsibility to
supply or arrange for this service.
There are two levels of maintenance, the first consists of tasks which are
performed by the user/operator, and the second are those tasks to be
performed by qualified X-ray service personnel.
A periodic maintenance service should be performed every six or twelve (6 or
12) months after installation.
The manufacturer undertakes to have available spare parts for this equipment
for at least ten (10) years after the unit's manufacturing date.
NEVER ATTEMPT TO PERFORM MAINTENANCE TASKS
WHILE THE EQUIPMENT IS IN USE WITH A PATIENT.
The tasks of this periodic maintenance shall include the following items:
DO NOT REMOVE ANY COVER, DISASSEMBLE OR
MANIPULATE
EQUIPMENT. THESE ACTIONS COULD CAUSE SERIOUS
PERSONAL INJURIES AND / OR EQUIPMENT DAMAGE.
NEVER ATTEMPT TO CLEAN ANY EQUIPMENT PART WHEN
IT IS SWITCHED ON. ALWAYS SWITCH OFF THE SYSTEM
BEFORE CLEANING
ELECTRICAL SUPPLY BEFORE CLEANING.
1. Switch the system OFF.
2. Externally check the proper cable connections between each major
component in the X-Ray System.
INTERNAL COMPONENTS
AND ISOLATE
DX-D 600
User Manual
OF THE
THE MAINS
163