AGFA DX-D 600 User Manual page 117

5.2.2 VERTICAL MOVEMENTS
RAISING
LOWERING
0242F EN 20181218
THE TABLETOP
LONGITUDINAL AND TRANSVERSE AXES WHEN MINIMAL
FORCE IS APPLIED. IF THE PATIENT IS STILL ON THE
TABLE, HE MAY NEED HELP TO STEP DOWN FROM THE
RAD TABLE.
DO NOT TRY TO MOVE THE TABLETOP LONGITUDINALLY
NOR TRANSVERSELY WITHOUT PRESSING THE CONTROL
PEDAL. DAMAGES CAN BE CAUSED TO THE PATIENT, TO
THE OPERATOR OR TO THE EQUIPMENT.
The vertical movements (raise and lower) of the Tabletop can be performed by
both central Control Pedals, RAISING and LOWERING.
1. To raise / lower the RAD TABLE, press and hold the RAISING /
LOWERING Control Pedal.
2. Raise/lower the Tabletop up to the desired position.
maximum/minimum heights have not been reached, continue pressing it.
3. Release the Control Pedal, the Tabletop will get locked automatically.
4. The Tabletop automatically stops when:
The Control Pedal is released.
G
It reaches to the configured intermediate height. This height is
G
configured in field.
It reaches the maximum/minimum height.
G
An obstacle is found during Tabletop movement.
G
CAN ALSO MOVE
DX-D 600
User Manual
FREELY IN
If the
109