Replacing A Rear 4X 2.5-Inch Hdd Backplane - Fujitsu PRIMERGY RX2540 M6 Upgrade And Maintenance Manual

Concluding steps
▶
"Reassembling" on page
▶
"Connecting the power cord" on page
▶
"Switching on the server" on page
▶ If applicable,
"Installing the front cover with lock" on page
▶ Update the system information of your server using the Chassis ID Prom
Tool, see "Using the Chassis ID Prom Tool" on page
corresponding system name.
▶
"Performing a RAID array rebuild" on page
7.7.4

Replacing a rear 4x 2.5-inch HDD backplane

Field Replaceable Unit
(FRU)
Tools:
Phillips PH2 / (+) No. 2 screw driver
Preliminary steps
▶
"Locating the defective server" on page
▶ If applicable,
"Removing the front cover with lock" on page
▶
"Shutting down the server" on page
▶
"Disconnecting the power cord" on page
▶
"Getting access to the component" on page
▶ Release all HDD/SSD modules and pull them out a few centimeters, see
"Removing a 2.5-inch HDD/SSD module" on page
The HDD/SSD modules need not to be removed. But if you want to
remove them nevertheless, check if all HDD/SSD modules are
uniquely identified so that you can reinsert them into their original
bays.
RX2540 M6
Hard disk drive (HDD) / solid state disk (SSD)
60.
65.
69.
52.
Upgrade and Maintenance Manual
110. Select the
106.
Hardware: 10 minutes
49.
53.
56.
169.
69.
52.
221