Installing an EDSFF dummy module
CAUTION
▶
If the removed HDD/SSD module is not replaced immediately,
always replace a dummy module into the unused HDD/SSD bay to
comply with applicable EMC regulations and satisfy cooling
requirements.
Figure 97: Installing the EDSFF dummy module
▶ Push the dummy module into the empty bay until it engages.
Concluding steps
▶ If applicable,
"Switching on the server" on page
▶ If applicable,
"Installing the front cover with lock" on page
7.5.10.4
Replacing an EDSFF SSD module
Customer Replaceable
Unit (CRU)
Tools:
– Installation frame included: tool-less
– Installation frame excluded: Phillips PH1 / (+) No. 1 screw driver
RX2540 M6
Hard disk drive (HDD) / solid state disk (SSD)
Upgrade and Maintenance Manual
69.
69.
Hardware: 5 minutes
195