▶ Insert the front VGA cable in the cable clip (see circle).
▶ Connect the front VGA cable to the system board connector "Front VGA".
Concluding steps
▶
"Installing the air duct" on page
▶
"Installing the fan cage" on page
▶ If applicable,
"Installing the riser module 1" on page
▶
"Reassembling" on page
▶
"Connecting the power cord" on page
▶
"Switching on the server" on page
▶ If applicable,
"Installing the front cover with lock" on page
14.4.2
Removing the front VGA
Upgrade and Repair Unit
(URU)
Tools:
– Phillips PH2 / (+) No. 2 screw driver (for cover 2)
– hexagon screw driver 5 mm (for front VGA)
Preliminary steps
▶ If applicable,
"Removing the front cover with lock" on page
▶
"Shutting down the server" on page
▶
"Disconnecting the power cord" on page
▶
"Getting access to the component" on page
▶ If applicable,
"Removing the riser module 1" on page
▶
"Removing the fan cage" on page
▶
"Removing the air duct" on page
RX2540 M6
79.
76.
60.
65.
69.
52.
74.
78.
Upgrade and Maintenance Manual
72.
69.
Hardware: 5 minutes
53.
56.
70.
Front panel
52.
457