Replacing A 16X Edsff Ssd Backplane (Bottom) - Fujitsu PRIMERGY RX2540 M6 Upgrade And Maintenance Manual

▶
"Connecting the power cord" on page
▶
"Switching on the server" on page
▶ If applicable,
"Installing the front cover with lock" on page
7.5.10.6

Replacing a 16x EDSFF SSD backplane (bottom)

Field Replaceable Unit
(FRU)
– Phillips PH2 / (+) No. 2 screw driver
Tools:
– Hexagon screw driver 7 mm
Preliminary steps
▶
"Locating the defective server" on page
▶ If applicable,
"Removing the front cover with lock" on page
▶
"Shutting down the server" on page
▶
"Disconnecting the power cord" on page
▶
"Getting access to the component" on page
▶ Release all EDSFF SSD modules and pull them out a few centimeters, see
"Removing an EDSFF SSD module" on page
CAUTION
The HDD/SSD modules need not to be removed.
▶
If you want to remove them nevertheless, check if all HDD/SSD
modules are uniquely identified so that you can reinsert them
into their original bays.
▶ Release all dummy modules and pull them out a few centimeters, see
"Removing an EDSFF dummy module" on page
▶
"Removing the fan cage" on page
RX2540 M6
Hard disk drive (HDD) / solid state disk (SSD)
65.
69.
52.
74.
Upgrade and Maintenance Manual
Hardware: 10 minutes
49.
53.
56.
194.
191.
69.
52.
201