Fujitsu PRIMERGY RX2540 M6 Upgrade And Maintenance Manual page 529

▶ Connect all cables to the system board.
For the cable plans, see
Concluding steps
▶ If applicable, install the TPM, see
▶ If applicable, install the Dual microSD 64GB Enterprise, see
Dual microSD 64GB Enterprise" on page
▶ If applicable, install all M.2 SSDs, see
▶ Install the iRMC microSD card, see
page 492.
Ensure that you install the iRMC microSD card that was installed in
the system board before the replacement.
▶ If applicable, install all expansion cards, see
on page 256.
▶
"Installing the cross bar" on page
▶
"Installing the fan cage" on page
▶ Install all riser modules, see
▶ For a system with air cooling, proceed as follows:
▶ Install all memory modules, see
page 338.
Ensure that you reinstall each memory module in the slot it was
located before the replacement.
CAUTION
In case of Optane PMem modules are not reinstalled in the right
slots, data can be lost!
▶ If applicable, install all dummy memory modules, see
memory dummy module" on page
RX2540 M6
"Appendix B" on page
"Installing the TPM" on page
"Installing the M.2 SSD" on page
"Installing the iRMC microSD card" on
81.
76.
"Installing a riser module" on page
"Installing a memory module" on
343.
Upgrade and Maintenance Manual
System board and components
571.
506.
"Installing the expansion card"
"Installing a
481.
"Installing the
498.
72.
529