Fujitsu PRIMERGY RX2540 M6 Upgrade And Maintenance Manual page 515

Replacing the microSD card
CAUTION
(not valid for Europe, Middle East, India and Africa)
The microSD card contains customer information.
▶
After removing the microSD card, hand the card over to the
customer.
▶
If the customer requests disposal of the defective microSD card,
proceed as follows: Using a pair of side-cutting pliers, cut the
microSD card in half.
▶ Remove the Dual microSD 64GB Enterprise, see
microSD 64GB Enterprise" on page
▶ Remove the defective microSD card from the Dual microSD 64GB
Enterprise.
Proceed as described in the following:
▶ To eject the defective microSD card, gently push it in and then let go.
▶ Pull the microSD card straight out of its slot.
▶ Install the new microSD card on the Dual microSD 64GB Enterprise.
Proceed as described in the following:
▶ With the label facing up, insert the microSD card into the microSD slot on
the controller until it locks in place.
▶ Install the Dual microSD 64GB Enterprise, see
64GB Enterprise" on page
Concluding steps
▶ If applicable,
"Installing the riser module 1" on page
▶
"Reassembling" on page
▶
"Connecting the power cord" on page
▶
"Switching on the server" on page
▶ If applicable,
"Installing the front cover with lock" on page
RX2540 M6
509.
505.
60.
65.
69.
Upgrade and Maintenance Manual
System board and components
"Removing the Dual
"Installing the Dual microSD
72.
69.
515