Fujitsu PRIMERGY RX2540 M6 Upgrade And Maintenance Manual page 484

System board and components
Tools: Removing the system board:
– Phillips PH2 / (+) No. 2 screw driver
– Torx 30 screw driver
Removing the TPM:
– Bit screw driver
– flat nose pliers
– TPM bit insert
(*)
For Japan:
– TPM module fixing tool (S26361-F3552-L909)
CAUTION
▶
Advise your contact persons that they must provide you with all
recovery keys which belong to the system to restore them in the
TPM later.
Preliminary steps
Preliminary steps are not necessary, if a system board has to be
replaced and the TPM is used again.
▶ Before removing the TPM board, remove the BitLocker protection and
decrypt the volume, see
volume" on page
▶ Disable the TPM in the system board BIOS, see
system board BIOS" on page
▶
"Suspending BitLocker functionality" on page
▶ If applicable,
"Removing the front cover with lock" on page
▶
"Shutting down the server" on page
▶
"Disconnecting the power cord" on page
▶ Remove all PSUs, see
484
(*)
"Removing BitLocker protection and decrypting the
485.
485.
"Installing a hot-plug PSU" on page
Upgrade and Maintenance Manual
"Disabling the TPM in the
87.
52.
53.
52.
124.
RX2540 M6