Fujitsu PRIMERGY RX2540 M6 Upgrade And Maintenance Manual page 357

Figure 230: Installing the EVAC CPU heat sink
▶ Install the EVAC CPU heat sink in the same way.
▶ Fasten the two additional screws (see circles).
Torque: 0.6 Nm
Upgrading the main memory
▶ Select an adequate memory configuration for "2 CPUs populated", see
"Basic information" on page
▶ Install memory modules, see
Installing three additional fan modules
In case of 1 CPU configurations with dual rotor fans, the bays 4, 5 and 6
are occupied with fan cage foams.
RX2540 M6
346.
"Installing memory modules" on page
Upgrade and Maintenance Manual
Processor (CPU)
336.
357