Fujitsu PRIMERGY RX2540 M6 Upgrade And Maintenance Manual page 215

Figure 115: Connecting the cables to the rear HDD backplane (example with SATA cable)
▶ Connect the following cables to the rear HDD backplane:
1 Power cable to HDD backplane and connector "PWR9" on system
board
2 OOB cable to HDD backplane and connector "SMB3" on system
board
3 SAS/SATA cable depending on configuration
For the cable plan, see chapter
RX2540 M6
Hard disk drive (HDD) / solid state disk (SSD)
"Appendix B" on page
Upgrade and Maintenance Manual
571.
215