Fujitsu PRIMERGY RX2540 M6 Upgrade And Maintenance Manual page 13

6.3 Redundant power supply
6.3.1 Installing a hot-plug PSU
6.3.2 Removing a hot-plug PSU
6.3.3 Replacing a hot-plug PSU
7 Hard disk drive (HDD) / solid state disk (SSD)
7.1 Safety notes
7.2 Basic information
7.3 Handling HDDs or SSDs without installation frame
7.3.1 3.5-inch HDD and 3.5-inch installation frame
7.3.2 2.5-inch HDD/SSD and 2.5-inch installation frame
7.3.3 2.5-inch HDD/SSD and 3.5-inch installation frame
7.3.4 EDSFF SSD and EDSFF installation frame
7.4 3.5-inch HDD configurations
7.4.1 Overview of configurations
7.4.1.1 Configuration with up to 10 HDD modules
7.4.1.2 Configuration with up to 12 HDD modules
7.4.2 Installing 3.5-inch HDD modules
7.4.3 Removing 3.5-inch HDD modules
7.4.4 Replacing a 3.5-inch HDD module
7.4.5 Replacing the 10x 3.5-inch HDD backplane
7.4.6 Replacing the 12x 3.5-inch HDD backplane
7.5 2.5-inch HDD/SSD configurations
7.5.1 Overview of configurations
7.5.1.1 Configuration with up to 16 HDD/SSD modules
7.5.1.2 Configuration with up to 24 HDD/SSD/PCIe SSD modules
7.5.1.3 Configuration with up to 24 PCIe SSD modules
7.5.1.4 Configuration with rear 2.5-inch HDD/SSD/PCIe modules
7.5.2 Installing 2.5-inch HDD/SSD modules
7.5.3 Removing 2.5-inch HDD/SSD modules
7.5.4 Replacing a 2.5-inch HDD/SSD module
7.5.5 Installing 2.5-inch PCIe SSD modules
7.5.6 Removing 2.5-inch PCIe SSD modules
RX2540 M6 Upgrade and Maintenance Manual
Content
124
124
127
130
133
133
134
136
136
137
139
141
143
143
143
144
145
148
150
152
155
159
159
159
160
162
164
165
168
171
172
175