Fujitsu PRIMERGY RX2540 M6 Upgrade And Maintenance Manual page 523

Preliminary steps
▶
"Locating the defective server" on page
▶
"Note on network settings recovery" on page
▶
"Suspending BitLocker functionality" on page
▶ If applicable,
"Removing the front cover with lock" on page
▶
"Shutting down the server" on page
▶
"Disconnecting the power cord" on page
▶ Disconnect all external cables.
▶ If applicable, remove the OCP modules, see
on page 252.
▶ Remove all PSUs, see
▶
"Getting access to the component" on page
▶ For a system with air cooling, proceed as follows:
▶
"Removing the air duct" on page
▶ Remove all memory modules, see
page 341.
Before removing the memory modules, take a note on the
installation slot number for each memory module. Ensure that you
reinstall the memory modules in the slot they were located before
the replacement.
CAUTION
In case of Optane PMem modules are not reinstalled in the right
slots, data can be lost!
▶ If applicable, remove all dummy memory modules, see
memory module" on page
RX2540 M6
52.
"Removing a hot-plug PSU" on page
78.
"Removing a memory module" on
341.
Upgrade and Maintenance Manual
System board and components
49.
265.
87.
53.
"Removing an OCP module"
56.
52.
127.
"Removing a
523