Safety; General Safety Rules; Electrical Safety; Mechanical Safety - WAGO 765-1103/100-000 Manual

765-1103/100-000

Safety

2

2.1 General Safety Rules

• This documentation is part of the product. Therefore, retain the documentation during
the entire service life of the product. Pass on the documentation to any subsequent
user of the product. In addition, ensure that any supplement to this documentation is
included, if necessary.
• The product must only be installed and put into operation by qualified electrical special-
ists per EN 50110‑1/-2 and IEC 60364.
• Comply with the laws, standards, guidelines, local regulations and accepted technol-
ogy standards and practices applicable at the time of installation.

2.2 Electrical Safety

Power Supply
• Only operate the product with safe extra low voltage power sources (PELV or SELV).
• Connecting impermissible current or frequency values may destroy the product.
Grounding/Protection/Fuses
• Connect the product and system to functional ground (FE).
• When handling the product, please ensure that environmental factors (personnel, work
space and packaging) are properly equalized. Do not touch any conducting parts.
Cables
• Maintain spacing between control, signal and data lines and the power supply lines.
• Only use conductor cross-sections sufficient for the current load.
Protection
• When working on the system (e.g., during maintenance), protect the facility part in
question from accidental or unauthorized restart.

2.3 Mechanical Safety

• Cooling of the product must not be impaired. Ensure air can flow freely and that the
minimum clearances from adjacent products/areas are maintained.
• Before startup, please check the product for any damage that may have occurred dur-
ing shipping. Do not put the product into operation in the event of mechanical damage.

2.4 Thermal Safety

• The surface of the housing heats up during operation. Under special conditions (e.g., in
the event of a fault or increased surrounding air temperature), touching the product
may cause burns. Allow the product to cool down before touching it.
• If the surface temperature of the product can exceed 55 °C, wear protective gloves and
attach protective covers and/or touch-proof protection.
Product manual | Version: 2.2.0
16DO FLD PN DC 24V 2.0A
Safety
11