Lan - B&R Panel PC 2100 User Manual

BIOS setting Function
Center mode Displays the image in the middle of panels with-
out a scaler chip
Table 200: Advanced - Graphics (IGD) configuration - IGD configuration
1) LFP = Local flat panel.
2) This setting is only possible if IGD - Boot type is set to CRT, EFP or LFP.
3) This setting is only possible if IGD - Boot type is set to LFP.
4) This setting is only possible if IGD - Boot type is set to Auto or EFP.

1.6.4 LAN

BIOS setting Function
PXE ROM Option for configuring PXE boot features
WakeOnLAN from S5 Option for switching on the system via the on-
board Ethernet controller (ETH1) from the S5
mode.
Panel PC 2100 user's manual V1.11
Configuration options
Disabled
Auto
CRT
EFP
Figure 123: Advanced - LAN
Configuration options
Disabled
Onboard ETH1 only
Onboard ETH2 only
Both onboard only
Add-on only
Any
Disabled
Enabled
Table 201: Advanced - LAN
Software • BIOS options
Effect
Disables this function
Enables this function for all connected pan-
els/monitors
Enables this function for CRT monitors
Enables this function for panels
Effect
Disables this function
Enables this function for ETH1
Enables this function for ETH2
Enables this function for ETH1 and ETH2
Enables this function for an optional add-on
card
Enables this function for all devices, ETH1 and
ETH2
Disables this function. The Ethernet controller
cannot switch on the system.
Enables this function. The Ethernet controller
can switch on the system.
205