Headlamp Housing Removal; Headlamp Housing Installation; Tail / Brake Lights; Bulb Replacement - Polaris 2012 RANGER RZR 570 INTL Service Manual

Headlamp Housing Removal

1. Disconnect the wire harness from the headlamp bulb.
Be sure to pull on the connector, not on the wiring.
2. Remove the O-rings (A) from the headlamp brackets
on both sides of the headlamp.
3. Remove the adjustment screw (B) from the bracket.
Image for Reference Only
A
4. Carefully remove the he
bumper.
Image for Reference Only

Headlamp Housing Installation

1. Install th e hea dlamp ho using ba ck into th e fron t
bumper.
2. Secure the headlamp housing with the rubber O-rings
(A) on both side s o f the hea dlamp an d install the
adjustment screw (B).
3. Reconnect wire harness or re-insert bulb if previously
removed.
4. Adjust h eadlights using the " Headlight Adj ustment"
procedure in this section.
B
A
adlamp from the front
9923523 - 2012 RANGER RZR 570 Service Manual
© Copyright 2011 Polaris Sales Inc.

TAIL / BRAKE LIGHTS

Bulb Replacement

Before replacing the bulb(s), use a dig ital multi-meter to
test the harness to ensure the lamp is receiving 12 volts
and that a ground path is present.
If a tail light, brake light or turn signal (INTL Only) does not
work the bulb may need to be replaced.
1. Disconnect the wire harness.
2. Remove bulb by turning the rubber base 1/4 turn and
pulling the bulb out. Repl ace it with recommended
bulb. Apply Dielectric Grease (PN 2871329).
Tail / Brake
INTL
Tail / Brake
Models
Turn Signal
Light
3. Test the tail lig ht, br ake lig ht an d tur n sign al ( INTL
Only) to verify it is working properly.
ELECTRICAL
Light
Light
10.19
10