VERSION 02/2018
OPERATING MANUAL
7.4.11 DISPLAY DURING SPRAYING MODE
Control unit in standby position
Ready to spray using R2 recipe (see figure).
The nominal value LEDs illuminate as dots and the high-voltage
value is digitally displayed in the LED display. If you press the
current limiter push button, the set nominal value for the
spray current limiter is digitally displayed in the LED display.
Spray display
Spraying using recipe R2:
By actuating the trigger on the spray gun, high voltage is
produced. The LEDs light up in a bar display showing the
actual values. The current actual value of the activated push
button for the high voltage (kV) is digitally displayed on the
LED display. If the push button for the spray current limiter
is pressed, the relevant LED lights up and the corresponding
actual value in µA appears on the LED display.
7.4.12 STANDBY MODE
If you want to spray without high voltage, select standby
mode. Briefly press the "Standby" push button (3), LED (4) will
illuminate. All other LEDs are extinguished.
Press push button (3) to return from this standby mode to the
previously saved standby mode (see figure).
Note:
This function can be activated and used from the gun.
ORDER NUMBER DOC 2366717
80
100
60
80
R1
40
60
20
40
R2
10
20
kV
µA
R3
80
100
60
80
R1
40
60
20
40
R2
10
20
kV
µA
R3
80
100
60
80
R1
40
60
20
40
R2
10
20
kV
µA
R3
4
3
80
100
60
80
R1
40
60
20
40
R2
10
20
kV
µA
R3
POWER
POWER
0
1
AquaCoat
B_03379
POWER
POWER
0
1
AquaCoat
B_03380
POWER
POWER
0
1
AquaCoat
B_03381
POWER
POWER
0
1
AquaCoat
B_03379
63