Program Copy - Okura Yusoki A Series Manual

8.2.

Program copy

Note
:
When a program copied from other is used for actual stacking, mating with
the peripheral conveyor control may be failed from time to time. It is much
easier for you to create a new program not by copying other one but created
by [OXPA mode] screen.
Copy procedure
(1) Choose [Program copy].
(2) Choose programs to copy from list.
(3) Enter program No. in copy destination.
(4) Click on [Execute] button.
(5) When repeat, repeat (2) through (4).
(6) Press [Close] button to close [OXPA auxiliary function].
Caution
You cannot copy if some programs are in copy destination. The programs
need to be deleted or the other program No. is to be designated.
8-4