Okura Yusoki A Series Manual page 60

only for "Labels out" also you can use for changing direction of products. The
"Variable pick" setting is must done before create pattern.
st th nd
Following figure is "Labels out" pattern. You can see 1 layer 4 product and 2
st th th
layer 1 , 3rd, 4 , 5 layer are "Labels out."
1st layer 2nd layer
Note:
After the selection of "Variable pick", in standard sequence program hand
turns 180 degrees between step 9 (MOV9) to Step 1 (MOV1). For prevent
this move the ENCHK and COUNT commands before Step 9 (MOV9) as
below.
WTARM
0ENCHK M6006
COUNT
MOV 9
5-2