Okura Yusoki A Series Manual page 17

3.1.2. Start new project
"Start new project" screen shows up clicking on "Start new project button at [Project
selection].
Enter [Project ID], [Project comment], choose [Robot type], [Conveyor station],
[Pallet station] and click on [OK].
In the following example, enter "1x1111" (don't use SPACE) to [Project ID] and
"Okura Test Robot" to [Project comment]. Choose "A1800N", "2", "2" to [Robot
type] [Conveyor stations], [Pallet stations] respectively.
Click on [OK] at [Start new project] screen then the below configuration message
pops up. Click on [OK] if everything is ok.
3-3