Okura Yusoki A Series Manual page 170

11.1.7. Gap of prd on sta
The crevice is entered, when leaving a crevice and holding two conveyance things on
a station.
Note:
Please the following station information must make the type in "Fixed type
(For double E.E.)".
Hand
Product
Station
11.1.8. Turn direction
If a turning device is used to rotate each product 90 degrees on the station conveyor,
the station conveyor, the "Turn direction" field is used. Select if the product will be
turned clockwise or counter-clockwise.
11.1.9. Side label dir above conveyor
This is set only when the "2 stations to 1 pallet" is ON. Along the flow direction of the
products, side label direction is set to "right side" or "left side". If there are side
labels at both sides, major side is recommenced to use.
Product
Gap of prd on sta
Station conveyor position
11-6