Editing Step Position Coordinate - Okura Yusoki A Series Manual

6.7.

Editing Step position coordinate

Step position data can be edited. Edit them clicking on each position coordinate. You
can cancel by ESC key what you edited.
In all the coordinates at arm, hand, pallet or station, the numbers are shown in unit
of 0.1mm. So fraction number can be used in editing.
[Other reference program]
By clicking "Other reference program" reference program list box displays. Select the
reference program form this box.
[Ref all copy]
Copy position data of all axes of reference program to that of program to edit.
[Ref surface copy]
Copy only planar position data of reference program to that of program to edit.
[Ref height copy]
Copy only height data of reference program to that of program to edit.
6-29