Table 53 Iq Behavior Drop-Down Menu - Configuration Of Pin 2 (I/Q) For Io-Link Class A De- Vices; Table 54 Possible Values Of The Inspection Level Parameter - WAGO 765-4203/0100-0000 Product Manual

765-4203/0100-0000
Setting the Filter Time for Digital Inputs
The filter time for the digital inputs can be selected from the Digital input signal filter
drop-down menu. You can select from the following values:
• No digital input filter
• 3 ms
• 15 ms
• 20 ms
If the No digital input filter option is selected, no filtering occurs.
Configure Pin 2 (I/Q)
The behavior of pin 2 (I/Q) can be selected from the IQ behavior drop-down menu. For
your IO-Link class A device, the following configuration options are available for using
pin 2 as a digital input or output:
Selection Option
Not supported
Digital input, normally
open
Digital input, normally
closed
Digital Output
Digital output, static on
Configuring the Device Check for Validation and Backup
Note
In the "IOL Autostart" operating mode (see above), this drop-down menu has no ef-
fect.
The Validation and backup drop-down menu can be used to determine whether a vali-
dation (device check) is performed and, if so, at what level (Inspection Level) when a con-
nected device is replaced, and whether or not the stored operating parameters of the old
device are carried over to the new one.
The following table explains the possible values for Inspection Level:
Inspection Level
NO_CHECK
TYPE_COMP
IDENTICAL
Product manual | Version: 1.0.0
4PORT IOL-A FLD EC DC 24V 2.0A
Table 53: IQ Behavior Drop-Down Menu – Configuration of Pin 2 (I/Q) for IO-Link Class A Devices
Explanation
Pin 2 is not used.
Pin 2 is a digital input.
Pin 2 is a digital input. The signal is inverted.
Pin 2 is a digital output.
Pin 2 is a digital output. The signal is permanently set to logic 1 (for testing pur-
poses only).
Description
No device check is performed.
A device check for type compatibility is performed.
For the device check, the actual vendor ID is compared to the vendor ID setting in
the configuration, and the actual device ID is compared to the device ID setting in
the configuration.
A device check for device identity is performed.
For this purpose, a device check for type compatibility is performed. Furthermore,
the actual serial number is compared to the serial number setting of the configura-
tion.
Table 54: Possible Values of the Inspection Level Parameter
Commissioning
75