Quality; Revision Id; Baud Rate; Cycle Time - WAGO 765-4203/0100-0000 Product Manual

765-4203/0100-0000
Value
2
3
4
5
6
7
8
9
254
255

10.3.1.3.5 Quality

This shows the Port Quality Info, including information on the validity of the process data
for input and output (separately). The content is binary coded.
Bits of Port Quality Info
Bit 0
Bit 1
Bit 2 to bit 7

10.3.1.3.6 Revision ID

This shows the version ID of the connected device.
A value of 0 means: no device connected.
All other values must be interpreted as the version ID of the connected device.

10.3.1.3.7 Baud Rate

If an IO-Link device is connected to the port, its data transmission rate appears here. For
IO-Link, the transmission rate of the communication between the port and a connected
device can have the following values:
• 4.8 kbit/s (COM1)
• 38.4 kbit/s (COM2)
• 230.4 kbit/s (COM3)
If no IO-Link device is connected to the port, the text Not connected appears here.

10.3.1.3.8 Cycle Time

The cycle time of the master is bit-coded as follows:
• Bits 0 ... 5 specify a whole-number multiplier between 0 and 63.
• Bits 6 ... 7 specify the calculation formula to use according to the following table:
Product manual | Version: 1.0.0
4PORT IOL-A FLD EC DC 24V 2.0A
Port Status
Incorrect Device
Preoperate
Operate
DI CQ
DO CQ
Reserved
Reserved
Incorrect Cycle Time
Port Power Off
Not Available
Description
0 = input process data valid
1 = input process data invalid
0 = output process data valid
1 = output process data invalid
Reserved
Commissioning
Description
The version or compatibility check
failed
The product is ready for communi-
cation
The product is communicating
The port is in digital input mode
The port is in digital output mode
Reserved
Reserved
The cycle time according to the con-
figuration does not correspond to
the connected product
The port voltage is switched off
The port is not available
Table 49: Meaning of the Individual Bits
71