Parameterizing The Module Via The Wago I/O Field Webserver; Configure Ports; Table 51 Port Configuration Settings For Io-Link Devices - WAGO 765-4203/0100-0000 Product Manual

765-4203/0100-0000

10.3.1.4 Parameterizing the Module via the WAGO I/O Field Webserver

You can make the following settings on the module with WAGO Webserver I/O Field:
8 Accessing a Connected IO-Link Device [} 77]
•
8 Configuring Ports [} 73]
•
8 Configuring IP Parameters [} 80]
•
8 Storing Maintenance Information [} 80]
•
8 Updating Firmware [} 82]
•
• 8 Resetting Module to Factory Settings [} 83]
• 8 Configuring Bluetooth [} 84]
• 8 Logging Users on and off and Managing Them [} 87]
• 8 Forcing Digital Inputs and Outputs [} 90]
• 8 Forcing IO-Link ports [} 91]

10.3.1.4.1 Configure Ports

The Configuration tab is used to display and modify the following port settings for the se-
lected port of the device:
Name
Port mode (pin 4)
Digital input signal filter
(pin 4)
IQ behavior (pin 2)
Validation and backup
PortCycleTime
Product manual | Version: 1.0.0
4PORT IOL-A FLD EC DC 24V 2.0A
Table 51: Port Configuration Settings for IO-Link Devices
Type Description
Drop-down menu Port operating mode (configuration of pin 4)
Drop-down menu Filter time for digital input signals on pin 4 (only for
"Port mode (pin 4)" on digital input)
Drop-down menu IQ behavior of the port (configuration of pin 2)
Drop-down menu Validation and Backup Settings for Device Check
When Replacing Devices
Input field Expected cycle time of the port
Figure 17: Port XX Menu Item, Configuration Tab
Commissioning
73