Off-Line Mode - Stratasys Objet500 User Manual

Objet500 User Guide
3. Enter the computer name or its IP address, or click Browse to find and
4. Click OK.
If you can see the material levels in the "Job Manager Screen" (see Figure
5-104 on page 5-83), Objet Studio is connected to the printer.
Normally, there should be no reason to change the printer connection.
Occasionally, however, you may need to reset the connection, to connect the
server to another printer, or to use Objet Studio in off-line mode (without a
printer connection).
Note: A printer can be listed by its name or by its computer's I P address.

Off-line Mode

You can use Objet Studio to prepare trays for printing in off-line mode, on a
remote computer or when the printer connection is not available. You also
use off-line mode to prepare trays for printing with other printers. In this
case, if Objet Studio is currently connected to a printer, you must change to
off-line mode by removing this connection.
DOC-07027 Rev. E
select it.
Figure 5-106 Connecting to a printer (B)
When the connection is established, Objet Studio is configured to prepare
print jobs for that printer.
5 Using Objet Studio
5-86