Objet500 User Guide
Resuming Production After Printing has Stopped
If the printing process is interrupted, Job Manager stops sending slices to the
printer. This can happen, for example, if the printing material runs out in the
middle of a print job, and you do not replace the empty cartridge immediately.
After the printer changes to Standby or Idle mode, you need to resume
printing from the Job Manager screen of Objet Studio.
After printing stops, the printer goes into Standby mode, when heating of
the print heads is reduced. About 10 hours later, the printer goes into Idle
mode, when heating of the print heads is stopped.
To continue printing the model:
1. If the printer is in offline mode, switch it to online mode by clicking the
2. If you don't know why printing has stopped, make sure that the
3. In the Job Manager screen of Objet Studio, click the Resume icon
4. In the Continue from Slice dialog box that appears, confirm the slice
DOC-07027 Rev. E
red button at the bottom of the printer interface (see Figure 6-3 on page
6-4).
The button changes from red to green (see Figure 6-3 on page 6-4).
connection between the printer and the server computer is active.
number, after checking the printer interface.
Figure 6-6 Printer interface after interrupted printing
Figure 6-7 Continue from Slice
6 Operating and Maintaining the Objet500 3D Printer
.
6-10