Stratasys Objet500 User Manual page 184

Objet500 User Guide
8. The following screen appears when the printer is ready for you to replace
9. Put on the protective gloves and open the printer cover.
DOC-07027 Rev. E
The printer heats and empties the print block, and prepares the printer.
(This should take up to 15 minutes.)
Figure 6-70 Printer preparation progress screen
print heads.
Figure 6-71 Printer ready for head replacement
Note: The printer disconnects power to the heads for your safety.
6 Operating and Maintaining the Objet500 3D Printer
6-53