Stratasys Objet500 User Manual page 179

Objet500 User Guide
14. After confirming all of the items listed in the wizard screen, click Next.
15. Carefully remove the resin container from the scale and empty it into the
Caution: The resin in the container is uncured
To prevent contact with skin, wear neoprene or nitrile gloves.
l
Dispose of uncured resin in accordance with applicable regulations. By
l
emptying the container into the purge unit, the resin is stored in the
printer's sealed waste container.
16. Close the printer and click Next.
17. When the following screen appears, remove the scale and clean the build
DOC-07027 Rev. E
Printing material (resin) is jetted from each head and its weight is
automatically recorded. This process is repeated for each printing mode,
after which the following screen appears.
Figure 6-63 Emptying the resin container
purge unit in the printer. Then return the container to the scale.
The printer cures the remaining resin in the container.
tray.
Figure 6-64 Remove the scale confirmation screen
6 Operating and Maintaining the Objet500 3D Printer
6-48