Objet500 User Guide
There are additional settings that you can select for special purposes (see
"Advanced Settings"). If necessary, click Advanced Settings before
clicking Next.
9. Click Next to begin the material replacement process in the printer.
Symbols:
The correct cartridge is in this slot.
No cartridge (or the incorrect cartridge) is in this slot.
The cartridge in this slot has insufficient weight to complete the material
10. Replace material cartridges as necessary, according to the instructions in
11. Click Start.
12. Read the warning message, and click OK.
DOC-07027 Rev. E
❒ Economy. This cycle can be used when replacing a light-colored Model
material with a darker material (such as TangoBlack™ or VeroBlack™)
or if the exact color of the printed models is unimportant. Use this
cycle when replacing cleaning fluid with any Model material.
The wizard flushes the system with the minimum amount of material
needed to ensure that models have the mechanical properties of the
new material.
❒ Full. Use this cycle when the printed models must have the exact color
of the new material.
The wizard thoroughly flushes o f the feed tubes and print heads
needed for printing, based on your selections in the previous screens.
The Cartridge positioning screen appears, showing you the new location
of all cartridges in the material cabinet.
Figure 6-10 Cartridges placement
replacement process.
The expiration date of the cartridge in this slot has passed.
the wizard screen.
6 Operating and Maintaining the Objet500 3D Printer
6-14