Objet500 User Guide
Model Quality When Digital Material Mode is Used
Near-high-quality is achieved for most models.
l
If all objects on the tray are inserted from individual stl files, they are
l
printed with the standard resolution of 600 dpi (dots per inch) along the
Y-axis—unless glossy finish is required (see "Surface Finish" on page 5-
23).
If there is an assembly on the tray, all of the models on the tray are
l
printed with a resolution of 300 dpi along the Y-axis.
3. Click Next.
Model Material
Substitution
4. Click Build.
DOC-07027 Rev. E
The Model Material Substitution dialog box opens—if this is relevant for
the tray. (If not, the Job Summary dialog box opens—continue with step
4.)
Figure 5-75 Model Material Substitution dialog box
If you allow the use of substitute model materials, the printer will use
different materials whose characteristics (strength, flexibility, etc.) are
similar to those of the material you assigned to the object when designing
the build tray—under the following conditions:
❒ The material you assigned is not installed in the printer at the time of
printing.
In this case, the tray is printed with either one or two substitute
materials (depending on the materials installed in the printer at the
time of printing). If possible, High Speed mode is used.
❒ In addition to the material you selected, there is another (similar)
material installed in the printer at the time of printing.
In this case, High Speed mode is used, by printing with a mixture of
the two materials (as if they were the same material).
If the build tray file has not been saved, the Save As dialog box opens for
you to save it now.
5 Using Objet Studio
5-60