Objet500 User Guide
6. Loosen the screw securing the UV lamp cover (A), and pull the cover up
7. Pull the UV lamp reflector out of the print block.
8. Inspect the new UV lamp reflector, and make sure that a black strip is
9. Discard the old UV reflector and lamp.
Dispose of the used UV lamp in accordance with environmental and
safety requirements.
DOC-07027 Rev. E
(B), then out (C).
Figure 6-109 Removing the UV lamp cover
Figure 6-110 Removing the UV lamp reflector
attached to the inside of it. If not, install one—on the side of the reflector
opposite (not next to) the print block.
Note: Extra black strips are included in the printer Start-Up Kit. If necessary,
you can remove the black strip from the old reflector and install it in the new
reflector (as long as the black paint has not faded).
6 Operating and Maintaining the Objet500 3D Printer
6-72