Stratasys Objet500 User Manual page 162

Objet500 User Guide
8. Remove any pieces of waste material collected in the purge unit.
9. Inspect the wiper.
10. In the wizard screen (see Figure 6-30), confirm that the wiper blade is
11. Remove all tools and cleaning materials from the printer, and close the
12. Confirm this in the wizard screen, and click Next.
13. Click Done to close the wizard.
DOC-07027 Rev. E
If necessary, remove the waste collector to clean it. Wipe the rubber seal.
Figure 6-31 Purge unit waste collector
Note: When returning the waste collector to the purge unit, make sure to
insert it as shown.
If the wiper is scratched, torn or worn, or if you cannot clean it
completely, replace it.
a. Grasp it and pull it up and out of its bracket.
b. Insert the new wiper blade, making sure that it is straight and secured
well on both sides.
clean, and click Next.
cover.
Figure 6-32 Confirmation screen
6 Operating and Maintaining the Objet500 3D Printer
6-31