Objet500 User Guide
If you continue, you must complete the material replacement process
before you can produce models. To replace material cartridges at another
time, click Cancel. If you continue (by clicking OK) and you do not
complete the process, you will need to run the wizard again before
producing models.
13. Click Done to close the wizard.
14. Inspect the area around the purge unit and clean it, if necessary.
Caution
Dispose of all material cartridges in accordance with all applicable laws
and regulations. If necessary, the cartridges can be disassembled for
recycling. If this is done, protect the person handling the cartridges from
direct exposure to uncured resins.
After changing the type of Support material (SUP705/706), run the Head
Optimization wizard. See "Optimizing (Calibrating) Print Heads" on page
6-43.
DOC-07027 Rev. E
Figure 6-11 Final wizard screen
The printer-control application is automatically updated, and the interface
displays the new material(s). Objet Studio (on the server computer) is also
updated and displays the new material(s).
6 Operating and Maintaining the Objet500 3D Printer
6-15