Objet500 User Guide
4. Make sure that the build tray is in place and clear (empty), confirm this in
➢ When using a Stratasys UV sensor box that you connect to the printer
➢ When using a stand-alone UV radiation meter, continue with "External
UV Sensor Connected to Printer
The following steps apply when using the Stratasys UV sensor box that you
connect to the printer. They do not apply when using a U V external radiation
measuring device.
1. To synchronize the wizard and the UV sensor, enter the CF number from
DOC-07027 Rev. E
the wizard screen and click Next.
Figure 6-90 Printer preparation
(TOL-03005-S), continue with "UV Sensor Connected to Printer" below.
UV Meter" on page 6-65.
the label on the back of the UV sensor box and click Next.
Figure 6-91 UV sensor synchronization
6 Operating and Maintaining the Objet500 3D Printer
6-63