Objet500 User Guide
Changing the
When you design a build tray in Objet Studio, you can use model materials
Model Material
that might not be currently installed in the printer. Because the installed
materials are displayed by default, change the material selection settings on
the Tray Settings ribbon, if necessary.
Figure 5-26 Selecting a new model material
Changing the
To change the type of Support material:
Support
1. In the printer application, run the Material Replacement Wizard (see
Material
2. In Objet Studio:
You can override the default grid style settings for the current print job in
the Advanced Properties dialog box (see "Choosing the Support
Strength" on page 5-63).
You can set the default grid style in the User Preferences dialog box (see
"Setting User Preferences" on page 5-74).
When you send a print job to the printer, the new Support material a ppears in
the Available Resources section of the Job Manager screen.
Figure 5-27 Available Resources in Job Manager
DOC-07027 Rev. E
"Changing the Printing Material" on page 6-12).
❒ When changing to SUP706, the recommended Grid Style is "Lite."
Note: Cleaning models printed with Standard or Heavy grid style can
clog the filter in DT3 and CS
these models with a WaterJet cleaning station.
❒ When changing to SUP705, the recommended Grid Style is
"Standard."
II
P cleaning stations. If necessary, clean
5 Using Objet Studio
5-26