Objet500 User Guide
23. I n the next wizard screen, confirm that you have removed all tools and
24. C lose the printer cover.
25. A fter replacing print heads, you should check the head alignment before
DOC-07027 Rev. E
objects from the printer.
Figure 6-83 Cleared-tray confirmation screen
The wizard continues by heating the heads, then filling and purging them.
If there are no installation problems, the optimization procedure begins,
to calibrate the print heads to the best working configuration—
"Optimizing (Calibrating) Print Heads" on page 6-43.
If installation problems are detected, the wizard alerts you and instructs
you how to continue (see "Installation Problems", next).
using the printer to produce models. In the final wizard screen:
❒ Select Optimize all print heads and click Next. Run the Head Alignment
wizard.
Figure 6-84 Final wizard Screen
6 Operating and Maintaining the Objet500 3D Printer
6-59