Objet500 User Guide
Setting the
When you open Objet Studio for the first time in a client installation, you are
Remote Printer
prompted to connect to a server computer that sends jobs to a 3D printer. To
Connection
do this, the server computer must be operating and connected to the local
(Client Mode)
network.
To set (or change) the connection to the server-computer:
1. On the Job Manager ribbon, in the 3D Printer group, click
2. Enter the name of the server computer or its IP address, or click Browse
3. Click OK.
The Job Manager ribbon has three icon groups:
Job Manager
Commands
Icons are enabled or disabled according to their relevancy. For example, since
you cannot stop printing a job that is not being printed, the Stop command is
disabled when the printer is idle.
DOC-07027 Rev. E
to find and select it.
Figure 5-111 Printer Server Connection dialog box
❒ 3D Printer
❒ Queue
❒ Job
Figure 5-112 Job Manager ribbon commands
5 Using Objet Studio
.
5-89