Replacing The Odor Filter - Stratasys Objet500 User Manual

Objet500 User Guide
4. In the next wizard screen, observe the numbers and wait until the level is
5. Select the check box, and click Next.
6. Click Done in the final wizard screen.
Replacing the
If the printer exhaust is not connected to an external ventilation system, a
Odor Filter
built-in activated-carbon filter removes odors from printing materials. This
filter should be replaced regularly (as necessary) to keep your working
environment pleasant.
DOC-07027 Rev. E
Figure 6-102 Confirmation of cartridge removal
relatively stable—two units above or below the average level shown.
Figure 6-103 Level stabilization
Figure 6-104 Final wizard screen
6 Operating and Maintaining the Objet500 3D Printer
6-69