Table of Contents
Advertisement
Objet500 User Guide
UV Radiation
The UV lamps used in the printer emit dangerous radiation.
➢ If the UV lamps remain on when the printer is open, do not stare directly
Printer
➢ Service operations should be performed only by qualified personnel who
Maintenance
➢ Notify co-workers and those who have access to the Objet500 system
Report any potential dangers and safety-related accidents to your safety
officer or to other appropriate authorities.
Model and Support materials are made of chemical substances. Although
Model and
precautions must be taken when handling these materials directly, all Model
Support
and Support materials used by the Objet500 system are handled in sealed
Materials
cartridges. Normally, operators of the printer should never be directly exposed
to hazardous materials. In the unlikely event of a leak or spill, follow the
instructions that are included with the printing-material cartridge used.
➢ Store Model and Support materials indoors, in a dry area with adequate
➢ Keep Model and Support materials away from areas where food and drink
➢ Uncured printing material is considered a hazardous substance, requiring
➢ When handling UV-cured models that may not be completely cured on the
➢ To prevent respiratory irritation, ventilate areas where Model and Support
➢ Clean up Model-material and Support-material spills with disposable
➢ Do not wash contaminated clothing at home; clothing should be
➢ Dispose of contaminated shoes, belts and other leather items in
DOC-07027 Rev. E
at the UV light. Shut down the printer and call your Stratasys service
provider.
have been instructed in relevant safety precautions.
before beginning non-routine and hazardous work.
ventilation, between 15-25 degrees Celsius (59-77 degrees Fahrenheit).
Never expose them to flames, heat, sparks, or direct sunlight.
are stored, prepared and consumed.
certain precautions when directly handling it. To prevent skin irritation,
wear neoprene or nitrile gloves. If there is any chance that Model and
Support materials might splash into the eyes, wear safety goggles.
Prolonged direct contact with printing materials can cause an allergic
reaction.
surface, common latex gloves are adequate.
materials are used. If the printer is not equipped with an exhaust duct, the
room ventilation system should replace the air at least 20 times per hour.
towels or other absorbent, non-reusable material, such as sawdust or
activated charcoal. Rinse the spill area with denatured or isopropyl alcohol
(IPA), followed by soap and water. Dispose of the absorbent material in
accordance with local regulations.
professionally laundered.
accordance with any applicable regulations. Absorbed printing material
may re-expose the user when these items are worn.
2 Safety
2-5
Advertisement
Chapters
Table of Contents
