Stratasys Objet500 User Manual page 180

Objet500 User Guide
18. In the wizard screen, confirm that the build tray is clear and that the
Replace print heads only after consulting with a Stratasys-authorized
customer-support engineer.
DOC-07027 Rev. E
cover is closed, and click Next.
The wizard uses the data collected to analyze the condition of the print
heads and optimize them so they print models with a uniform layer of
material.
❒ If the heads are in satisfactory condition, the following wizard screen
appears.
Figure 6-65 Final wizard screen, after optimizing print heads
❒ If the wizard determines that a print head is faulty—or that it is
negatively affecting model quality with the current head
configuration—you need to replace it. Indicate whether or not you
want to do so now.
Figure 6-66 Defective print heads found
❒ Choose Replace defective head(s) if you are prepared to replace the
print heads now (see below).
or—
❒ Choose Abort wizard if you want to replace the print heads at another
time.
6 Operating and Maintaining the Objet500 3D Printer
6-49