Objet500 User Guide
4. Loosen the two screws securing the suction tube on the print block.
5. Lift the suction tube to secure it in a raised position.
6. Remove the two screws securing the covering of the roller waste collector
Be very careful to save the covering screws. These are special screws; if
they are lost, you need to order replacements.
7. Remove the covering by pulling it out, and then lower it.
DOC-07027 Rev. E
Figure 6-37 Lifting the suction tube
and remove it.
Figure 6-38 Removing the roller waste collector covering
6 Operating and Maintaining the Objet500 3D Printer
6-35